Initial Setup
If the
‘
PWR
’
is off, the heater will not start.
Press and release the
‘
PWR
’
and ‘OK’
buttons together, pressing
and releasing ‘
PWR
’ and ‘
OK’
buttons will turn the thermostat on to the most
recently selected working mode or the factory default setting if not previously
programmed.
Note small Red LED Display light will be displayed constantly while heater is
on.Will
flash intermittently when unit is not in operation.
Press and release the
‘
PWR
’
will shut unit down.
Setting the day of the week and time.
Setting the hour function.
Press and release the ‘
UP
’ or ‘
DOWN
’ button to increase or decrease the
hour setting by 1 hour.
Press and hold the ‘
UP
’ or ‘
DOWN
’ button for 2 seconds or longer to
increase or decrease the hour setting by 1 hour every 0.5 seconds.
Press ‘
OK
’ to accept and select the minute.
Setting the minute function.
Press and release, or press and hold down the ’
UP
’ or
‘DOWN ’
button to
increase or decrease the minute setting by 1 minute similarly to the hour
setting.
Press ‘
OK
’ to accept and select the day of the week.
Setting the day of the week function.
Press and release the ‘
UP
’ or ‘
DOWN
’ button to change the day of the
week to the following or previous day. Press and hold the ‘
UP
’ or ‘
DOWN
’
button for 2 seconds or longer to increase or decrease the day of the week
by 1 day every 0.5 seconds.
Press ‘
OK
’ to complete setting.
The time and day of the week is now set.
Page 8.
Note: Use the outer edge of buttons to toggle through functions.
Back up Switch.
In the event that Thermostat remote is in operative ie Flat batteries or
damaged unit can still be used but only on the one factory setting of high fire
Medium fan. Unit will start as per normal 3 minutes on Low Fire and Fan,
but them will go to High Fire, Medium Fan. This switch is only for use in the
event of failure of Remote Thermostat.
With the thermostat off, press and hold the ‘
T
’ button for 2 seconds or
longer to initiate programming the time.
Time
, the
hour
setting and the
AM / PM will flash.
Page 11.
Setting the period starting time.
The hour and AM / PM settings will now flash. To set the P1 starting time,
press and release the ‘
UP
’ and ‘
DOWN
’ button to increase or decrease
the hour setting. Press and hold the ‘
UP ’
or ‘
DOWN
’ button for 2 seconds
or longer to increase or decrease the hour setting by 1 hour every 0.5
seconds.
The hour function is in 12 hour time, so please ensure that AM or PM is
set correctly.
To accept the hour press ‘
OK
’.
The minute setting will flash. Adjust the minute setting similarly using ‘
UP
’
or ‘
DOWN
’ buttons.
To accept the minute press ‘
OK
’.
Setting the temperature.
The temperature setting will now flash. Press and release the ’
UP
’ or
‘
DOWN
’ button to increase or decrease the temperature setting by 1°C.
Press and hold th ‘
UP
’ or ‘
DOWN
’ button for 2 seconds or longer to
increase or decrease the temperature setting by 1°C every 0.5 seconds.
To accept the temperature press ‘
OK
’.
Period 1 is now set for the day/s of the week that you have chosen. The
LCD will display
P2
to indicate that period 2 can now be set for the same
day/s of the week.
Repeat the programming process for periods 3 and 4.
After program 4 is set, press ‘
OK
’ and the program for the selected day/s
will be set.
The thermostat will now automatically turn off.
Repeat the programming process for any other periods/days that are
required.
ON
OFF
