16
This menu lets you configure your downrigger so that the weight depth will
read
0
when the weight is slightly below the water surface, regardless of the
distance from the boom to the water surface. Additionally, a sub menu allows
you to set the cable type to 200 or 400 feet. Both of these settings typically need
adjustment only once.
Follow the instructions below:
1) Move the weight to a position just under the boom.
2) Press the
MENU
key three times from the depth screen to enter the zero
depth menu.
3) Adjust the zero depth to reflect the distance from the boom to the water
surface (plus a 1 ft tolerance). For example, if the distance to the top of
the water surface from the boom is 1 ft, set this value to -2.
4) Now turn the Digi-Troll IV OFF and turn it ON again. The weight depth
must display the zero depth that you selected.
5) Lower the weight to slightly below the top of the water surface and verify
that the depth reads
0
.
Note:
At any time when
AUTO UP
key is pressed, the weight is raised to the
water surface. Pressing the
AUTO UP
a second time brings the weight to the
boom from the water surface. In order for this function to perform accurately,
your zero depth setting must reflect the actual distance from the boom to the
water surface.
Press the
RCL
key to display or adjust the cable type setting; CA4 indicates a
length of 400 feet and CA2 indicates 200 feet. Use
UP
or
DOWN
key to adjust if
necessary. The default setting reflects the cable type that was installed at the
factory.
Zero Depth Menu
Bottom Depth Display
(Optional Transducer Required
)
This feature allows your downrigger to be used as a depth finder by
continuously displaying the bottom depth. Note: At other times, you can still
display the bottom depth by pressing and holding the
RUN
key.
In order to use this option, your downrigger must be:
1) Configured as a
MASTER
with the optional sonar transducer installed
OR
2) Configured as a
SLAVE
and connected to a
MASTER
downrigger using
the optional interface cable.
Press the
MENU
key six times from the depth screen or once from the Down
Speed menu. The bottom depth will be displayed. Unlike the previous menus,
this does not time-out after 10 seconds. Note: The two icons
DEPTH
and
BOTTOM
will flash continuously to remind you that the display contains the
bottom depth and not the depth of the weight. To revert back to the default
weight depth screen, press the
MENU
key.
OPE
R
A
T
ING &
PROGRAMMI
NG
PE
RA
TING & P
R
OG
RA
MMIN
G
AnglingOutpost.com
1-888-356-5022
AnglingOutpost.com
1-888-356-5022
