7
Telephone set-up
6
Product information
The reverse side of Wellbeing call system device
1. DC Adapter connector: Power adapter supply jack
2. N.C SW switch: Usage switch of N/C Type SW of the option sensor connection
• When you don't use the sensor of N/C Type SW with Option Sensor, you must place the switch at
"Delete".
3. Bell sound switch: Switch for controlling the volume sound
4. line connector jack: Jack to connect to the phone line
5. OPTION Sensor: optional beside basic sensor to install additional sensor
: Caller’s ID information may not be transferred when used another communication device
beside telephone at home. Also, it may not be possible to check messages and remote control
of Wellbeing call system
Example)
Communication device connection: ADSL, Card Reader, DDD controller, cash
machine, sound proof system device..etc.
• When setting up the internet in a parallel circuit to the phone platform or phone
line, if you do not use a noise filter, there can be noise and even if you use the
noise filter, there could be a problem in caller’s ID signal and Wellbeing call system
action. (For noise and a trouble, contact the internet service company)
:
If you use the service in an area where there is no Caller ID service provided, Caller ID sign is
not shown. If calls from a payphone or from abroad and if the calling condition is not stable, the
number may not be shown.
Wellbeing call system set-up
1. Link a plug of Curl Cord to the handset; link the opposite plug to the jack in the side of the fixed device.
2. Fix the bell volume-controlling switch to the proper position of either "Big" or "Small".
In case when there is no additional installation of an optional sensor and N/C Type SW is not used for
optional sensor, you must place the switch to the "Delete". If there is an additional installation of an
optional sensor to set up N/C Type SW optional sensor, you must place the switch to the "Use".
3. Connect one plug of a Line Cord to the phone jack of the fixed device (phone device). Link the opposite
plug to the outlet of the Line Cord.
• The outlet of the Line Cord installed in general households is modular as standard. If the outlet is 4
terminal type, you should purchase 4 terminal type cord additionally.
4. Connect the power adapter to the AC220V outlet, and then connect the DC jack to the DC12V IN jack on
the fixed device.
• If AC220V outlet is on the wall, let the line of the adapter faces the ground when connected to the
power adapter.
5. If you hear the dial tone after connection set-up, the basic set-up has been completed correctly.
6. Rechargeable battery set-up
Open the battery cover on the bottom of the fixed device and connect the rechargeable battery pack to
the connector, place it in the case and close the battery cover.
• If you use another rechargeable batteries beside the designated products, it may cause a critical shock
to the product and there is a possibility for a dangerous accident, please do not use other products.
:
1. Place the rechargeable battery after completing the installation.
2. Separate the battery from the product if not used for a long time.
As we begin to set up the following procedure, please read the contents below and use and set up the
product according to the set-up procedure.
CAUTION
CAUTION
CAUTION
Summary of Contents for WCS-211
Page 2: ......