C&TT WCS-211, User Manual

Page: 6 / 19

9
Telephone set-up
Connect in series
Connect in parallel
Terminal block
Terminal block
8
Telephone set-up
Option sensor set-up and usage
The usage of the option sensor is designed to expand easily to install many sensors beside the basic
sensor after purchasing Wellbeing call system. The optional sensor allows the usage of all sensors if it is
“Normal Open Tyle SW joint” or “Normal Close Type SW joint”.
The most used “Magnetic Sensor” for the option sensor and we define the usage of this sensor in the
below.
■
Example of set-up and Magnetic sensor structure
use and connect to the picture sensor set up in many Magnetic windows.
For Normal Close Type sensor’s additional connection, the additional N/C sensor should be also
Normal Close Type.
Normal Close Type sensor is “Close” when both terminal joint points are separated and is “Open”
when the sensor and magnetic are together.
”Open” when the door is closed after setting up and “Short” when the door is open.
For Normal Open Type sensor’s additional connection, the additional N/C sensor should be also
Normal Open Type.
Normal Open Type sensor is “Open” when both terminal joint points are separated and is “Close”
when the sensor and magnetic are together.
Close” when the door is closed after setting up and “Open” when the door is open.
4. Decide the connection line according to the sensor joint action type (N/C or N/C) and connect to the SW
terminal(N/O SW or N/C SW) of the “OPTION SENSOR (terminal block)” on the bottom of the fixed
device.
•
• When using “N/C SW” of “OPTION SENSOR (terminal block”) you must place the switch to the “Use”
on the “N/C SW” on the reverse side of the fixed device. If not using “N/C SW” of “OPTION SENSOR
(terminal block”), you must place the switch to the “Delete” on the “N/C SW” on the reverse side of the
fixed device
• When setting up Alarm, the voice guiding message is “Door open is detected” by the option sensor.
: If there is a connection error or wrong switch choice of the “N/C SW” switch, it detects
it as the sensor error so the error action message and sensor detection is not working.
■
Magnetic sensor set-up and actions
1. Magnetic sensor installation is mostly designed to
protect from external invader by setting up at the
door and windows.
2. Wellbeing call system enables two types of
sensors that are “N/O” and “N/C” , used separately
or together. Two types of sensors may be installed
in series or in parallel.
•
Attention when setting up : The terminal block
joint type (N/O SW, N/C SW) of “OPTION
SENSOR” has the definition in the following.
(Based on the actual action)
N/0(Normal Open) :
N/C(Normal Close) :
3. Fix the Magnetic Sensor where the user wants it
to be placed.
Depending on the user’s environment, you may
One piece standard for a Sensor Condition
N/O, N/C are changed when MAGNETIC is placed
Set-up Magnetic Sensor Structur
CAUTION