31
Trouble-shooting checking
Wellbeing Call System
Communication & Telephone Tech. co., Ltd.
1
Press the button
• When wrong dial button is pressed
or the line is busy, press
button to call again.
1
Press the button once
• The volume goes from level 1 to
level 4 when pressing button
for once.
1
Choose the switch
*Choose between “Loud” and “Small”
for the bell switch.
1
Press the button
(Redial)
• When line is busy, put down and lift
the handset or press button
and button for automatic
dialing.
1
Press the button
(Pose)
• Pose function is entered without
lifting the handset and used to
registered a phone number for
Wellbeing call system and phone
number memo.
• used for line connection
VOLUME
VOLUME
FLASH
FLSH
FLSH
REDIAL/POSE
REDIAL/POSE
REDIAL/POSE
벨소리
소
대
Order
Method
Explanation
LCD display
Order
Method
Explanation
LCD display
Order
Method
Explanation
LCD display
Order
Method
Explanation
LCD display
30
HOW TO USE WELLBEING CALL SYSTEM TELEPHONE
■
FLASH function
• Use to make a phone call again. It is convenience to use when connecting to the key phone or PABX
(private exchange) thus to replace different internal users.
■
REDIAL/POSE function
• Press " " and button when using line from the key phone or PABX (private exchange)
and set up the input and record the telephone number.
■
SPEAKER VOLUME CONTROL
• The users can volume when calling the phone
■
REGULAR BELL VOLUME CONTROL
Symptom
Checklist for trouble-shooting
• No signal on the LCD
• No movement such as alarm set
up and no voice message
• Cannot set up the Wellbeing call
system
• Cannot set up and cancel the
alarm
• Voice message “There is a
problem in a sensor when setting
up alarm”.
• Cannot use telephone functions
(even when you press the dial
button)
• Siren rings when alarm is set up
• Voice message "Replace your battery"
when setting up the alarmalarm
• No report when sensor works fine
for alarm set up
• Cannot connect even when I press
the button after receiving the
alarm set-up report
• Remote control connection not
working
• No Caller’s ID shown
• Hear the sound "Bee" from the speaker
when calling from the speakerphone
• Is the power adapter connected correctly?
• Is the power adapter connected correctly?
• Refer to the Wellbeing call system input set up and Function set-up methods
and try it again.
• Is your handset put down correctly?
• Is your speakerphone on?
• Is the Wellbeing call system put on Stop?
• Did you use the correct password number when canceling the alarm set-up?
• Check whether there is a problem in the external part of the
sensor.
• Check whether the option sensor is connected normally if there
is an error voice message about the door open sensor. Also,
check whether N/C SW is placed correctly at the back side of the
phone.
• Is it set up as alarm?
• Are the power adapter and phone line connected?
• Are the power adapter and phone line connected?
• Did you use the assigned rechargeable battery package?
• Please change the battery.
• Did you registered the phone number?
• Try again after referring to the telephone number registration and
function set-up methods.
• Did you enter the button 9 and button POSE for the telephone
registration while using private exchange and key phone?
• Did you press button during the information message?
• Is this the correct password number?
• Do you use another communication device at the same line with
the Wellbeing call system? If yes, add noise filter, etc. It may still
cause a trouble for the caller’s ID and Wellbeing call system.
• Turn the speaker volume down with "Volume" button in case
there is a structural problem with a microphone.
Redial/pose
Summary of Contents for WCS-211
Page 2: ......
