6
Maintenance
40
How to Walk-Test the System
A walk-test allows you to test
your system's functions without
causing an alarm. You should
conduct a walk-test once a
week.
The first step of a walk-test is
to place your system in walk-
test mode. Then, walk in front
of motion sensors, and open
protected doors and windows.
Each time a sensor detects
your presence, the keypad
beeps, and lights the LED of
the most recently faulted zone
in its display.
If your system fails to detect a
sensor, exit the walk-test mode
and make sure the sensor's
zone is not bypassed. (The
LED of a bypassed zone blinks
slowly.) If the zone is by-
passed, remove the bypass
and repeat the walk-test. If
your system still fails to detect
the sensor, contact your service
representative.
IMPORTANT:
during a walk-
test, your building is not pro-
tected against actual alarms.
To Conduct a Walk-Test:
1.
Press and hold the
[walk test] key for 2 seconds
until you hear two beeps.
Enter the master user code.
You see the following pattern
of lit zone LEDs:
1 2 3 4 5 6 7
8
2.
Press the
key.
3.
Test your sensors by opening
protected doors and win-
dows, and by walking in front
of motion sensors. The key-
pad beeps twice each time
you open and close a pro-
tected door or window, or a
motion detector senses your
presence. The affected zone
LED lights.
4.
When done, press the
key.
Summary of Contents for Sierra
Page 1: ...Using Your Security System With LED Keypad S5030 S5031 S5032...
Page 64: ...60 8 Notes Notes...
Page 65: ...61 8 Notes Notes...
Page 66: ...62 8 Notes Notes...
