Candela VelaShape, Instruction Manual, Page: 32 / 60

Controlling the Treatment Level
You can adjust the level of each treatment mode, using the corresponding mode buttons:
• IR mode
• RF mode
• Vacuum mode
Use the mode buttons to control the intensity of IR, RF and Vacuum applied to the patient. Each
time you press the mode button, you move the intensity up to the next level, as indicated by the
lights on the operator panel. e.g., if the current level is 2, and you press the mode button, the
level goes to 3. After 3 it goes back to 0 (zero).
Table 2: Treatment Level Intensities
Level Intensity Notes
None
(mode turned off)
Low
Medium
Default level; set to avoid accidental activation
0
1
2
High 3
Communication Terminal Messages
During system operation the terminal's display LCD will always show a split view of the
applicators' operating conditions and other relevant information, such as:
• Ready – the applicator is connected, the treatment level configured, but the trigger is not yet
pressed.
• Treatment - the applicator is connected, the treatment level configured, and the trigger is
pressed.
• Not Available – the applicator is not connected.
Pressing the Info button on the terminal will make the following information available. Press the
Scroll button on the left side to view all of the information:
• System Type – VelaShape II.
• VelaShape II - System S/N – the system's factory serial number.
• LA/SA S/N – the Vsmooth applicator or Vcontour applicator type and factory serial number.
Copyright 2020 Product Guide. All Rights Reseved