SAFETY NOTE:
Take all necessary safety precautions when installing the top row of batteries and rack components,
as to not drop anything on the batteries below.
FIGURE #9
Install Front Side Restraint Rails and Covers.
FIGURE #10
Install End Restraint Brackets, Rails and Covers.
9
Front Restraint Rails:
With the batteries in place,
slide the front side restraint rails and covers up into
place. See Figure #9. There should be a maximum
of 1/8” gap between side restraint rails and covers to
batteries. If there is interference between battery and
rail, confirm that the battery is pushed to the back
for single row and towards the center for double
row racks. If there is still interference, stop and
contact C&D immediately. If there is a gap greater
than 1/8” (3mm), contact C&D immediately.
10
Battery Restraint Bracket:
Complete the installation
of battery restraint brackets, refer to Detail #4.
11
Install End Restraint Rails and Bracket:
Install corner brackets, end rails and covers.
Position end restraint rail and cover against end
of battery. See Figure #10 and Detail #5.
RSO1942 2/18/03 4:08 PM Page 2
