4000 AVE. PINARD,
ST-HYACINTHE,
QUÉBEC, CANADA,
J2S 8K4,
TEL: 450-383-4000,
FAX: 450-383-4004
www.ventecventilation.com
Sept. 8, 2016
PAGE 6 OF 17
REV 4
2
OVERVIEW OF THE PROJECT MECHANICAL INSTALLATION
2.1
PREPARING TO INSTALL THE FAN
Review
this
entire
manual
wi
th the
installati
on
t
eam and
shar
e
inform
ation
with
necessary
personnel.
Physically confirm the arrangements and locations of the system cyclones and controls. Verify your order
documents for the system configuration.
There are several components that can be assembled on the floor for easier cyclone system installations.
Consult
your
constructi
on
professionals.
Consult with your professional construction team and review this installation.
Review and prepare your electrical and structural building components.
Pl
an
to
receiv
e and
stor
e the
sy
stem
components.
Check inside the freight and inspect it while the driver is present. Report any damages to the driver and your
sales representative.
Store the freight in a location that has proper access for material handling and that will keep it in good
condition; avoid storing the material in corridors where tractors or other vehicles can cause damage.
Al
l
th
e
floor
work
should
b
e done
in
a
dedica
ted
workspac
e
to
begi
n
th
e
installation.
T
he
fans
hav
e
heavy
ey
e
loops
for
handling
and
hanging.
T
he
Cycl
one
Plus
is
heavy
and
awkwar
d to
handle.
Please
use
cautio
n and
maximu
m
safety
wh
en
handling.
The optional variable frequency drive (VFD) shall be resilient mounted and installed within a distance of
20
feet
from the fan.
The VFD shall be positioned upright to allow airflow out both sides of the heat sink.
The VFD motor wiring and terminations has to be done by licensed electricians.
In high moisture applications a waterproof connector and drip loop in the wire should be used.
Check sheaves and belts for alignment and tension in case they have moved during the shipping. They should
be adjusted if required.
The bearings should be inspected and greased as required. We recommend yearly greasing and maintenance.
Grease nipple is located on the back of the impeller shaft.
Inspect for defects or missing parts. Discrepancies shall be reported to the sales department.
PUTTING INNOVATION TO WORK
7686 16 Line, Arthur, ON.
N0G 1A0
Email: [email protected]
Tel: 1-800-263-5314
Fax: 519-848-3948
www.canarm.com
Summary of Contents for AgSystem CYCLONE PLUS
Page 2: ......
