4000 AVE. PINARD,
ST-HYACINTHE,
QUÉBEC, CANADA,
J2S 8K4,
TEL: 450-383-4000,
FAX: 450-383-4004
www.ventecventilation.com
Sept. 8, 2016
PAGE 15 OF 17
REV 4
8
START UP INFORMATION & DIAGRAMS
8.1
START UP PROCEDURE
Check that the power is turned off.
Check VFD and Wiring Terminations for tight connections.
Verify that the VFD is clean and dry.
Test power wiring for short and open circuits.
Ensure that suspension cable clamps or chain links are tight and closed.
Ensure the fasteners of the wall or post supports are tight.
Check that the cyclone and the circuit breaker or fuse clip is labelled.
Ensure that the fan turns freely and is quiet. Check the belts too.
Clear the area around and below the Cyclone.
Energize the power circuit.
Test the voltages at the drive and record them. Program the VFD per the VFD instruction manual. See
programming notes below.
Jog the fan motor on and off to ensure the proper rotation. The fan will turn clockwise looking
underneath the fan
.
No
te:
If
the fan
bl
ade
turns
co
unter
clockwise,
you
will
need to
de-energiz
e the fan
an
d
wait
for
the
VFD to
discharge.
T
hen
reverse
tw
o of the
motor
wiring
phase
terminal
s
le
ads.
Jo
g
the
fa
n again
to
ensure
th
e
proper
rotati
on.
Start the fan and check the airflow.
Setting the airflow. The deflector vanes can be adjusted to direct the air stream. Allow 2-3 minutes for air
flow stability before making more adjustments.
Check the settings of drive according to the following tables;
Check the operation of the VFD and fans with the GENSET ON.
8.2
VFD PROGRAMMING NOTES
By default, VFD should be programmed for the installation and ready to operate right off the box. .
In case of trouble, refer to the VFD Instruction Manual before programming VFD or call
Canarm
Service
department at
1-800-260-5314
.
A 3HP, 85% efficiency, 3-phase, 1760RPM, totally enclosed, fan cooled, alternating current motor drives the
cyclone fan. Verify the nameplate data of the motor and note this information to use in programming the VFD
parameters.
PUTTING INNOVATION TO WORK
7686 16 Line, Arthur, ON.
N0G 1A0
Email: [email protected]
Tel: 1-800-263-5314
Fax: 519-848-3948
www.canarm.com
Summary of Contents for AgSystem CYCLONE PLUS
Page 2: ......
