3.1.2
INSTALLATION OF THE AIR IN
If the air intake is not installed when th
NTAKE
he fan is delivered, follow these instructions otherwise s
M6x30mm Mech. Screw(x6), M6 Washer(x12), M6 Lock W
he screws too much.
4000 AVE. PINARD,
ST-HYACINTHE,
QUÉBEC, CANADA,
J2S 8K4,
TEL: 450-383-4000,
FAX: 450-383-4004
www.ventecventilation.com
skip to the next step.
Washer(x6) and M6
Install the t
Hex Nut(x6) (Se
hree pieces together with M
ee figure 6). Do not tighten t
Insert the in
Washer(x18), M
intake
an
d
the
3.2 TWO ST
3.2.1 STEP 1
Figure 6 -
ntake into the body and put
M6 Lock Washer(x9) and M6
blades.
TEP INSTALLATION
1
LIFT THE CYCLONE I
Installation
of
th
e
thre
e
piec
es
o
it in place with the remainin
Hex Nut(x9).
Make
sure
tha
N PLACE
f the intake
together
ng M6x30mm Mech. Screw(
a
t
y
ou
have
a
space
of
¼
inc
(x9), M6
ch
betw
een
the
Sept. 8, 2016
PAGE 8 OF 17
REV 4
Install the top of the fan housing at more than
4
feet
to the ceiling/roof deck.
Install the bottom of the fan shutter higher than
7
feet
above the ground.
Do not install fans where they may affect the performance of emergency sprinkler systems.
3.2.2 STEP 2
INSTALL CYCLONE DEFLECTORS
The outside deflector brackets and deflectors should be installed after the fan is securely mounted in order
to prevent damage to the deflectors.
If the fan is horizontal, the deflectors should be mounted to throw the air in both fan sides (see Figure 4).
If the fan is in angle, the deflectors should be mounted in the same direction in order to throw the air
horizontal (see figure 5).
PUTTING INNOVATION TO WORK
7686 16 Line, Arthur, ON.
N0G 1A0
Email: [email protected]
Tel: 1-800-263-5314
Fax: 519-848-3948
www.canarm.com
Summary of Contents for AgSystem CYCLONE PLUS
Page 2: ......
