04
The miner supports three modes: “Idle mode”, “Mining Mode” and “Con
fi
guration Mode”.
In this mode, the hash board is in a non-working state, and the control board is in a monitoring state, responding to API
commands at any time. This mode consumes the lowest power.
The miner has 3 modes: 1) power mode, 2) High-performance mode, and 3) Normal mode.
By default, the miner is set to perform in high-performance mode.
Normal mode has lower power consumption and hash rate compared with high performance mode.
It's an older mining
strategy, the new Power mode is a more flexible mining mode that offers more power and hash rate options.
Power mode (see Appendix VI for detailed operation) offers more power level choices. It is divided into two directions,
one is to reduce power consumption, the other is to increase power consumption in pursuit of greater computing
performance. Users can choose different directions and power levels according to specific requirements.
Users have the flexibility to choose the right working mode according to their own needs. The relevant parameters of
the different modes are re
fl
ected
in the product specification table.
●
After powering-on the miner and when the second red light
fl
ashes (about three seconds after powering-on), press
the FUNC key and the device will enter con
fi
guration mode.
●
While in con
fi
guration mode, the IP address is static (address: 192.168.168.168, subnet mask: 255.255.255.0). The
built-in web service of the miner can be accessed through a PC browser to configure the network, mining pool,
password, and other information.
●
Do remember to set the PC with a static IP address:
192.168.168.100 (or any Other non-conflicting address with the
same segment), subnet mask:255.255.255.0 and connect to the
same network with the miner (under the same switch or router, or
directly connect the miner to the network).
CHAPTER 3
OPERATING MODES
Mining Mode
Configuration mode
Idle Mode
