FLUIDS
rmo2010-001-006_b
FLUID REMOVED FOR CLARITY PURPOSE
1. Fill level line
9. Add recommended fluid as required.
Do not
overfill.
WARNING
Avoid getting brake fluid on skin or in eyes
— it may cause severe burns. In case of con-
tact with the skin, wash thoroughly. In case
of contact with the eyes, immediately rinse
with plenty of water for at least 10 minutes
and then consult a doctor immediately.
10. Immediately wipe up spills if necessary.
11. Ensure that the seal located inside the cap is
collapsed.
12. Reinstall the cap to the reservoir.
13. Tighten cap screws.
14. Wipe off reservoir if necessary.
Engine Coolant
WARNING
When opening the reservoir, the coolant can
be very hot and spray out if the engine is
hot. In order to avoid getting burned, check
coolant level when engine is cold.
Recommended Coolant
The cooling system must be filled with distilled
water and antifreeze solution (50% distilled water,
50% antifreeze).
For best performance, use
LONG LIFE ANTIFREEZE
(P/N 219 702 685)
.
Coolant Level Verification
WARNING
When opening the reservoir, the coolant can
be very hot and spray out if the engine is hot.
In order to avoid getting burned, check the
coolant level when the engine is cold.
1. Park the vehicle on a firm, level surface.
2. Open the front storage compartment.
3. Remove the plastic rivet from the right service
cover.
rmr2010-038-021_a
1. Right service cover
2. Plastic rivet
4. Pull down the service cover using the recess to
release upper tabs from the front fascia.
rmr2010-038-061_a
5. Pull out the rear tab.
6. Lift service cover to remove it.
NOTICE
Pay attention not to damage the FCS
switch.
7. Check the coolant level on the right hand side.
Coolant must be slightly above the COLD. level
mark.
38 / 52
2014-1
PREDELIVERY
