Can-Am RYKER 2023 Series, Operator'S Manual

Page: 125 / 222

123
13. Check the oil filter inlet and outlet
orifices inside oil filter cavity (inte-
grated part of magneto cover) for
dirt and contaminations.
1. Oil inlet orifice from the oil pressure pump
2. Oil outlet orifice to the engine lubrication
system
3. Oil filter receptacle
14. Replace the cover O-ring by a
N NE EW W one.
15. Remove the oil filter
16. Install the N
NE EW W oil filter into the
cover.
17. Apply engine oil on O-ring and on
end of filter.
18. Insert the oil filter in its location.
N NO OT TIIC CE E
P Pa ayy a atttte en nttiio on n tto o a avvo oiid d p piin ncch hiin ng g
tth he e O O--rriin ng g d du urriin ng g ffiilltte err a an nd d cco ovve err
iin nsstta alllla attiio on n..
19. Tighten oil filter cover to recom-
mended specification.
T Tiig gh htte en niin ng g tto orrq qu ue e
Oil filter cover
screws
9 ± 1 Nm
(80 ± 9 lbf-in)
20. Wipe off any oil spillage on engine.
21. Install N
NE EW W sealing washers on oil
drain plugs.
N NO OT TIIC CE E
N Ne evve err u usse e a a sse ea alliin ng g w wa assh he err a a sse ecc--
o on nd d ttiim me e.. A Allw wa ayyss rre ep plla acce e w wiitth h a a
n ne ew w o on ne e..
22. Install drain plugs and tighten to
the specified torque.
T Tiig gh htte en niin ng g tto orrq qu ue e
Magnetic
drain plug
30 ± 3 Nm
(22 ± 2 lbf-ft)
Secondary
drain plug
15 ± 2 Nm
(133 ± 18 lbf-in)
9 90 00 0 A AC CE E E EN NG GIIN NE E S SH HO OW WN N
1. Magnetic drain plug
2. NEW Sealing washer
3. Secondary drain plug
4. NEW Sealing washer
23. Refill oil tank at the proper level
with the recommended oil.
A Ap pp prro oxxiim ma atte e e en ng giin ne e o oiill
C Ca ap pa acciittyy ((w wiitth h ffiilltte err))
600 ACE
2.5 l
(2.64 qt (liq.,US))
900 ACE
2.8 l
(2.96 qt (liq.,US))
24. Reinstall the dipstick and tighten it
properly.
25. Start engine and let it idle for a few
minutes.
26. Ensure there are no leaks.
27. Stop engine and check oil level.
Refill if necessary.
28. Dispose oil and filter as per your
local environmental regulations.
MAINTENANCE PROCEDURES