ELECTRICAL
WARNING
Unless otherwise indicated,
al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
Spark Plug
Removal
Remove side panels.
Unplug spark plug cables.
Unscrew spark plugs one turn.
Clean spark plugs and cylinder heads
with pressurized air if possible.
WARNING
Always wear safety goggles when
using pressurized air.
Unscrew spark plugs completely then
remove them.
vmo2006-007-029_a
RH SIDE — REAR CYLINDER
1. Spark plug
vmo2006-007-030_a
LH SIDE — FRONT CYLINDER
1. Spark plug
Installation
Prior to installation, make sure that
contact surfaces of cylinder heads and
spark plugs are free of grime.
Using a feeler gauge, set the spark
plug gap between 0.6 to 0.7 mm
(0.024 to 0.027 in).
Apply anti-seize lubricant over spark
plug threads to prevent a possible
seizure.
Screw spark plugs into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
Torque
spark
plugs
to
20
N•m
(15 lbf•ft).
Battery
WARNING
Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
CAUTION: Never remove the bat-
tery sealing cap.
114
_____________________
Summary of Contents for Renegade 500
