11
STEERING LIMITER ADJUSTMENT
WARNING: Before going to the next steps,
make sure that stabilizing arms are correctly
installed, and that the angle of attack and
alignment are correct. Refer to the
User
Manual
supplied at purchase.
14.Turn the vehicle’s steering wheel to its maximum
point of travel on the left. While maintaining
pressure on the steering wheel, turn threaded rod to
adjust length of cable. See Fig. 26
15.Position cable end hole
(1)
19 mm [
¾
in.] short of
support plate
(2)
mounting hole. See Fig. 26
WARNING: To prevent potential damage to
vehicle components, the
** ¾ inch [19 mm] **
gap is mandatory.
Fig. 26
16.Reverse steering wheel a little to be able to bolt
support plate and cable together. Tighten provided
bolt
(C4)
to 35 N•m [24 lb•ft]. See Fig. 27. Repeat
steps on right side.
Fig. 27
FINAL INSTALLATION
1. Verify the suspension settings. If the shock
absorbers are adjustable, adjust them to the stiffest
setting to allow for maximum clearance between the
System and the vehicle’s fenders. See Fig. 28
Fig. 28
2. Verify for possible contact between Track System
and lower fender corners. See Fig. 29
Fig. 29
CAUTION: If there is contact, the fender should be
modified (cut) to avoid damage to the vehicle’s
components and premature wear on rubber track.
3. Lower the vehicle to the ground.
