CPB-515 Operation and Maintenance Manual
– TTS 45, 70, 80,100, 110 Series (10-2017)
13
IMPORTANT
Should a motorized lifting device be used, assistance on ground
during operation of handling, coupling and assembly is needed.
Do not stand between lifting device and axle assembly when
mounting axles to implement. Be careful: risk of injury.
7.
Lightly grease machined surface of center pivot pin and insert into the receiver end
of the axle. Rotate the pin to align the rear mounting hole in the receiver pin.
Install the bolt and locknut provided with the kit. Tighten pin bolt.
8.
Install the inner thrust washer against the axle pin flange.
9.
Apply a light amount of grease to the center pivot pin.
10.
Slide the undercarriage onto the axle pin. NOTE: Care must be exercised to avoid
damage to the lip seals on the center bore of the undercarriage assemblies during
installation. Using a fork truck, lift the undercarriage assembly onto the center pivot
pin.
Grease this
surface
