Campersat AutoSeek Autoskew
11
H4441 Build 4441 August 2008
•
To switch from receiver 1 to 2, press button A to B & vice versa for receiver 2
to 1
•
Power up TV and Satellite Equipment.
•
Set TV system to Receive Satellite Signals.
TV should display searching for signal. It is OK to leave Satellite Receiver settings
there.
Video Output
•
Connect the Scart Adaptor 7040G with (2) or 3 way connectors to the IN1 on
the (2)or 3 way AV Input switch(yellow-yellow, red-red, white-white)
•
Connect from receiver 1 (Free To Air or Select TV) to the IN2 on the (2)or 3
way AV Input switch and receiver 2 to the IN3
Connect Y-W-R connectors from OUT on the 3 way switch input to your TV
AV Connections
11. Adjust TV set and receiver
You have two possibilities to interconnect the receiver and the display (TV set). It is
enough to do only ONE of either the coax connection or SCART connection.
Coax connection
First, you need to connect the coax cable on both sides (TV and receiver) then you will
have to tune in your TV to the proper channel. To do so the AutoSkew just needs to be
powered up. Refer to your TV set manual how to operate your TV to tune in correctly.
SCART connection
This way needs no tuning of the TV set and will typically give a better picture quality,
therefore it is to be preferred. Simply connect the SCART cable into the receptacle
named “TV scart” on the receiver side and into the matching one on the TV side(use
adaptor provided & AV cables for this connection).
Almost any TV will auto detect the receiver when switched on and will automatically
change over to SCART input. If not, you need to refer to the TV manual to find how to
get the TV into the CART (AV) mode.Once the connection of the TV is OK you should
see at least some Onscreen Display menu coming from the AutoSkew receiver.
Press the red button on the AutoSkew remote again to retract the dish. With the dish
retracted the AutoSkew should switch to Standby immediately.
