Campersat AutoSeek Autoskew
6
H4441 Build 4441 August 2008
check for the correct direction! When you are sure, just stand on the plate with both feet
for a few seconds to press it on firmly. Any glue coming out on the sides can be cleaned
away. Now put in the 6 screws to give it some additional safety. Apply some glue to the
screws as well to make sure that they are fitted waterproof.
4. Place on the AutoSkew
First plug in the two connectors into the matching receptacle.The black cable has to be
fed out into the REAR direction. Now place the AutoSkew onto its mounting plate. Put
the cable into either one of the two given slots in the cabinet. Do not fix the box withthe
nuts for the moment.
5
. Fixing of the aluminium elbow (cable-feed-through)
Take care to fit the elbow in the correct way. The intake of the cable has to point to the
back of the vehicle.
a) Drill a hole of approx. 15mm (1/2 inch) into the roof. Decide the location of the hole
wisely to avoid any extra work inside the vehicle.
b) Place the elbow on its intended position above the hole. Do the necessary cable work
on the roof. Push or pull the cable through the elbow until you have a proper length
outside the vehicle. It will be very difficult to shift the cable after the final fitting of the
