UT10 Weather Station
It is common for air to be trapped behind the knee portion
of a j-bolt. Use a stick or rod to stir and tamp around each
j-bolt to insure proper anchoring.
CAUTION
6.
Remove the top nuts, washers, and j-bolt template pieces. Leave the two
bottom nuts and one flat washer on each j-bolt. Remove the template
frame and the concrete form.
2.1.2 Tower Installation
1. Install the mast as shown in FIGURE 2-4. Attach the 3/4 in x 10 in nipple
to the mast using the bell reducer. Loosen the two bolts at the top of the
tower and insert the mast. For a 3 m mounting height, rest the bell reducer
against the top of the tower. Tighten the two bolts to secure the mast.
FIGURE 2-4. Install the UT10 mast.
2. Remove the three 5/16 in bolts, nuts, and fender washers from the UT10
mounting brace (FIGURE 2-5).
3. Pivot the three mounting feet to the vertical position.
9
