Campbell ENC 10/12, Product Manual

Page: 25 / 51

NOTE:
For tripods requiring the enclosure mount receiver, the receiver may not be pre-installed on
the tripod at the factory. In this situation, the receiver and mounting hardware will be
shipped with the tripod and will need to be installed as shown in
FIGURE 6-13 (p. 18). The
CM106B, CM106BK, CM106 and CM106K tripods have flanges built into the tripod base and
do not require the enclosure mount receiver.
Attach the enclosure to the leg base:
1. For the CM110, slide the keyhole notch in one of the upper corners of the –LM mounting
bracket over the extended Phillips head screw located on the tripod (see A in FIGURE 6-14
(p. 19)). The CM106B, CM106BK, CM106 and CM106K have mounting hooks extending from
the tripod body in place of the Phillips screws (see B in
FIGURE 6-14 (p. 19)).
FIGURE 6-14. Upper mount location on CM110 (A) and CM106B (B)
2. One of the notches at the lower end of the enclosure mounting bracket will now align with
the flange on the lower tripod base (or the enclosure mount receiver on the CM110). Slide
the enclosure mounting bracket onto the flange (see
FIGURE 6-15 (p. 20)).
Enclosures 19