Campbell Hausfeld WK250000AV Operating Instructions And Parts Manual Download

Page: 3 / 48

◆

Do not allow persons wearing loose clothing or jewelry

to start or operate the unit. Loose clothing or jewelry
may become entangled in moving components, causing
equipment damage and or personal injury.

◆

To reduce fire hazard, keep the unit exterior free of oil,

solvent, or excessive grease.

◆

All installation, maintenance, repair and operation of this

equipment should be performed by qualified persons only in
accordance with national, state, and local codes.

◆

Verify that all components of the unit are clean and in good

condition prior to operation. Be sure that the insulation on
all cables and power cords is not damaged. Always repair or
replace damaged components before operating the unit.

◆

Check all fasteners at frequent intervals for proper tightness.

Do not operate the unit with the

cover removed.

◆

Always operate the unit in a clean, dry, well ventilated area.

Do not operate the unit in humid, wet, rainy, or poorly
ventilated areas.

◆

Always shut the equipment off prior to moving the unit.

Do not use to melt or thaw frozen pipes.

Risk to Equipment: Electrostatic

Discharge (ESD). The PC boards

can be damaged by electrostatic discharges. Always use
grounded a wrist strap before touching PC boards or other
electrical components. Always disconnect the power cord
before removing the cover.

Risk to Equipment: Overheating.

Do not exceed the rated duty cycle.

This unit is equipped with a duty cycle indicator. Allow
unit to cool before continuing.

ELECTRIC SHOCK HAZARD

ELECTRIC SHOCK can kill. Only a

qualified electrician should connect

input power. DO NOT touch electrically “live” or “hot” parts
or electrode with skin or wet clothing.

◆

Do not touch live electrical components.

◆

Insulate yourself from work and floor or ground with dry

insulating mats.

◆

Do not touch torch parts if in contact with the workpiece or

ground.

◆

Unplug the power cord before servicing this equipment.

◆

Only connect this equipment to an electrical outlet according

to this Instruction Manual and national, state, and local
codes.

◆

Keep cords dry, free of oil and grease, and protected from hot

metal and sparks.

◆

Turn off this equipment when not in use.

◆

Inspect and replace any worn or damaged torch cable leads.

◆

Keep away from torch tip and pilot arc when the trigger is

pressed.

◆

Clamp work cable with good metal-to-metal contact to

workpiece as close as possible to the cutting zone.

SPARKS HAZARD

FIRE AND EXPLOSION HAZARD.

Cutting sparks can cause fire or

explosion. NEVER cut on containers or pipes that contain,
or may have contained, flammable or combustible
materials or potentially toxic coatings or solvents. Check
and be sure the work area is safe before doing any cutting.

◆

Remove all flammable materials within 33 feet (10m) of the

cutting arc.

◆

Wear an ANSI (American National Standards

Institute) compliant helmet or shield to protect
your face and eyes sparks when cutting.

◆

Wear ANSI compliant safety glasses with side

shields under your helmet or shield.

◆

Wear oil-free protective garments such as welding gloves,

heavy shirt, cuffless trousers, high top shoes, and a welding
cap. Wear flame retardant ear plugs to keep sparks from
entering ears.