![background image](http://html.mh-extra.com/html/campagnola/nexi/nexi_use-and-maintenance-manual_488429026.webp)
Page 26
Use and maintenance manual – Translation of
original Instruction.: 00, Date 25/09/2020
WARNING!
With paper twist tie reels it is recommended to use only the first two tying modes (L1 and L2).
WARNING!
Do not work on trees or stairs, as it is extremely dangerous.
Before working with the tool, wear suitable protective clothing.
4.1.1 Tie reel replacement
1. Switch off the tool with the ON/OFF button (7) and remove the battery (14) by pressing on the release buttons (15).
2. Release the hook (2) and remove first the front cover (3) in the shown direction, then the tie pressing lever (1)
3. Remove any residual piece of tie from the supply line, the hook (4) and the tying wheel (5) using tweezers.
4. Re-insert the tie pressing lever (1) and reassemble the front cover (3) by hooking it again.
5. Remove the mobile sprocket (11) by turning it clockwise.
6. Insert the reel (12) checking the right tie winding direction.
7. Reassemble the mobile sprocket (11) by turning it anti-clockwise. Holding the tie end tight, cut the tie pieces outside
the reel (12).
8. Insert the tie extremity into the supply line till reaching the drive roller. Check whether the tie has been properly in-
stalled in the right direction and that it is neither coiled nor knotted.
9. Insert the battery (14) and switch on the tool by means of the ON/OFF button (7).
10. Press the trigger (6) to carry out a trial tying operation. If it is successful, remove it from the tying wheel (5) and go on
working.
If the tying operation has not been successful for several times, carry out a deeper inspection after switching off the tool
and removing the battery (14). Check whether the tie is not coiled or knotted at the front tying opening (10), in the supply
line, as well as around the hook (4). Check whether the tie direction is right.
Remove any tie pieces that may have got stuck.
If the tie is twisted, it is suggested to cut and remove the knotted part and then re-insert the tie according to the above-
mentioned procedure.