shown and install the connector
fitting to one end of the stand.
B. Connect the
two sides
of the stand
together as
shown.
C. Insert the
two ends of the
wires into the
brackets on the back
of the appliance as
shown.
D. Insert the tension
strap through the
bottom bracket of
the appliance and
pull tight.
OUTLET HOSE AND SHOWER
HEAD ASSEMBLY
Attach the shower nozzle to the
hose. Make sure to insert the
supplied rubber gasket at the
connection.
Connect the
opposite end of
the hose to the
brass fitting on
the bottom of
the appliance
labeled water
output. Make
sure to insert
the supplied
rubber gasket at
this connection.
Hand tighten only.
(OPTIONAL GARDEN HOSE CONNECTOR TO
OUTPUT)
An additional brass fitting for
connecting a standard garden hose
to the outlet of the appliance is
included. If connecting a garden
hose to the output first connect
the brass fitting using the supplied
gasket to the brass fitting on
the bottom of the
appliance labeled
water output. Hand
tighten only. Attach
the garden hose to this
connection. Make sure
the garden hose has a rubber gasket
inserted in the connector.
WATER SUPPLY INPUT ASSEMBLY
Attach standard
garden hose to
the fitting on the
bottom of the
appliance labeled
water input. Make
sure to insert the supplied rubber
gasket at the connection.
BATTERY INSTALLATION
Install 2 “D” cell batteries in the
compartment on the bottom of the
appliance. Make sure the batteries
are installed in the correct direction.
Clean the battery contacts and also
those of the device prior to battery
installation.
Always purchase the correct size and
grade of battery most suitable for
the intended use.
Do not mix new and used batteries.
Replace all batteries at the same
time.
INSTRUCTIONS FOR CONNECTING
REGULATOR TO APPLIANCE
• Attach gas
regulator to the
appliance. The
regulator will
attach the brass
fitting on the
bottom of the
appliance labeled
Gas Input. Tighten
the fittings using wrenches on both
the brass adapter fitting on the
appliance and the brass fitting on
RUBBER GASKET
RUBBER GASKET
RUBBER GASKET
RUBBER GASKET
THIS FITTING MUST BE HELD
WITH A CRESENT OR 7/8” END
WRENCH WHEN TIGHTENING
OR LOOSENING THE
REGULATOR HOSE.
