overfill. Immediately close LP tank
valve and call local LP gas dealer
for assistance.
• Do not release liquid propane (LP)
gas into the atmosphere. This is a
hazardous practice.
• To remove gas from LP tank,
contact an LP dealer or call a local
fire department for assistance.
Check the telephone directory
under “Gas companies” for nearest
certified LP dealers.
LP TANK EXCHANGE
• Many retailers that sell appliances
offer you the option of replacing
your empty LP tanks through an
exchange service. Use only those
reputable exchange companies
that inspect, precision fill, test and
certify their cylinders. Exchange
your tank only for an OPD safety
feature-equipped tank as described
in the “LP Tank” section of this
manual.
• Always keep new and exchanged
LP tanks in upright position during
use, transit or storage.
• Leak test new and exchanged
LP tanks BEFORE connecting to
appliance.
LP TANK LEAK TEST FOR YOUR SAFETY
• Leak test must be repeated each
time LP tank is exchanged or
refilled.
• Do not smoke during leak test.
• Do not use an open flame to check
for gas leaks.
• Appliance must be leak checked
outdoors in well-ventilated area,
away from ignition sources such
as gas fired or electrical appliance
away from open flames or sparks.
Use a clean paintbrush and 50/50
soap and water solution. Use
mild soap and water. Do not
use household cleaning agents.
Damage to gas train components
can result. Brush soapy solution
onto all weld seams and entire
valve area.
SETUP USING MOUNTING BRACKETS
This appliance may be mounted to
a non-combustible surface or used
on the wire ground stand. If the
appliance is to be mounted to a non-
conbustible surface attach using the
supplied hardware. For a temporary
mount the unit may be suspended
from the top bracket. If mounting
permanently the appliance should be
mounted using both the bottom and
top tabs
SET UP USING GROUND STAND
If the appliance is to use the portable
ground stand assemble the stand
together as shown below.
A. Slide the
loop of the
tension
strap over
the bottom
stand rod
If “growing” bubbles appear,
do not use or move the LP tank.
Contact an LP gas supplier or your
fire department.
WARNING
Hot exhaust gases exit from the
top of the appliance. The unit
should not be installed where
these hot gases could start a fire.
WARNING
If the wires are installed improperly
the appliance may tip over and
cause serious damage or fire.
WARNING
