proceeding.
4. Brush soapy
solution onto
indicated
connections
shown at right.
5. If “growing bubbles appear,
there is a leak. Close LP tank
valve immediately and retighten
connections. If leaks cannot be
stopped, do not try to repair. Call
for replacement parts. Order new
parts by giving the serial number,
model number and name of
the items needed to the Service
Center 1.435.752.3922.
6. Always close LP tank valve after
performing tank leak test by
turning hand wheel clockwise.
IF THE FLAME IS ACCIDENTALLY
EXTINGUISHED TURN OFF THE FLOW OF
THE WATER AND WAIT 5 MINUTES BEFORE
RESUMING THE FLOW OF THE WATER.
HOSE CHECK
• Before each use, check to see if
hoses are cut or worn. Replace
damaged hose assembly before
using appliance. Use only valve/
hose / regulator specified by
manufacturer. See product sheet
for hose & regulator information.
USING THE APPLIANCE
This appliance is equipped with
automatic on demand ignition. This
means that the appliance will light
and heat water whenever water is
running through the appliance. If the
water flow is stopped either at the
inlet or outlet the appliance will turn
off. When the flow of water is started
the appliance will automatically
reignite.
1. Turn on the gas supply at the tank.
(Open valve slowly.)
2. Turn the water valve on the front
of the appliance to high. Turn
the heat valve on the front of
the appliance to low. (This is the
lowest temperature setting)
3. Turn the water supply on. (If water
flows through the shower hose
the appliance will ignite.) If water
is not flowing through the shower
head the shower nozzle can be
rotated to the desired setting.
4. Once water is flowing through the
system the appliance will ignite.
During ignition there will be a
series of audible clicks and then
the burner will ignite. If the burner
does not ignite after 5 seconds see
the section on troubleshooting.
• Do not use appliance until leak
checked.
• If you cannot stop a gas leak,
immediately close LP tank valve
and call LP gas supplier or your
fire department.
WARNING
All cleaning and maintenance
should only be done when the
appliance is cool and with the fuel
supply turned off at the LP cylinder.
DO NOT clean any part in a self-
cleaning oven. The extreme heat
will damage the finish. Also check
for leaks at connection of hose to
appliance.
CAUTION
This appliance is capable of
producing scalding water. Extreme
caution should be used when using
the appliance.
WARNING
