Operation and maintenance instructions
Series PRE proportional pressure regulator
Analog /preset version
5000024670
Ver. 01
5
•
To reduce the noise levels caused by the discharge of air from the component, envisage the
use of silencers or convey the fluid to a zone where no personnel are envisaged during
normal operation.
•
Avoid covering the equipment with paint or other substances that may reduce heat
dissipation.
•
Avoid cleaning with aggressive agents such as to dull the plastics and make it difficult to
read the screen
•
In the event of an electrical power failure and pneumatic supply at the port connection 1,
the regulated pressure on port connection 2 will not be maintained and can be
discharged
.
4.
Product description:
The Series PRE electronic pressure regulator is composed of:
•
M12 8 pin connector (6): provides connection to power supply, command signal, feedback
signals and to the output signal (for more details refer to the paragraph “Installation and
Commissioning").
•
LCD display (1): if present (depends on the code), it shows the measurement of the
regulated pressure and allows to configure some parameters.
•
General diagnostic LED bar (3): provides a quick indication of the general status of the
device (for more details, refer to the "Use" paragraph).
•
Function keys (2): if the LCD display is present (depends on the code), these keys allow to
access and navigate the Regulator menu (for more details, refer to the "Use" paragraph).
•
Micro USB connector (5) and wireless communication LED (4) to connect to the UVIX: the
device can be connected to the UVIX supervision software via wireless (if present) or USB
that allows to configure and monitor the device.
