48
NOTE: Do not use a brake cleaning solvent to clean the track system.
This may damage sealing components and stickers
CAUTION: When pressure washing the track systems, care
must be taken to keep the water stream away from wheel
bearing seals and rubber caps.
CAUTION: If stabilizer rubber cone bores show sign of wear
and oval deformation, they must be replaced along with the
bolt and washer.
CAUTION: Make sure to grease wheel shafts and wheel
bearing seals.
CAUTION: Hub bearings should be checked every 50 hours of
use and, if necessary, replaced. Bearings that make noise and
restrict rotation of hub are indications that they must be
replaced.
CAUTION: Stabilizing rod and spring should be greased every
25 hours of use. Motorcycle chain lube is recommended.
CAUTION: Always replace the washer when removing hub
from frame. And when putting it back together, use a
threadlocker adhesive on M12-1.75 bolt that secures hub to
track frame.
CAUTION: Use a breaker bar to remove the M12-1.75 hub bolt.
Do not use an air impact wrench. It might cause the bolt to
break.