LIGHT series
ENGLISH
3.
Put a hand in the central part of the long hopper [D] and get hold of the two unions [A] and:
- insert the threaded pin [A1] of the union [A] in the hole of Ø 5 mm [D1] of the long hopper [D], then first insert the washer
[E] and then screw the winged nut M5 slightly [F];
- center the union [A] in the hole of Ø 150 mm of the hopper [D], then screw the winged nut M5 [F] permanently.
4.
Complete the installation by inserting the vent of 85x12,5 cm [G] in the long hopper [D], pressing slightly so that it fits into
place firmly.
Seeing as the appliance has 4 openings at the top, another two vents can be positioned also in adjacent rooms, provided the
fl
exible pipe has a short run (no more than 4 m), as straight as possible and e
ffi
ciently insulated in the run outside the
fi
nishing
mantle or another “long hopper kit” can be positioned in an opposite room.
0OMZXJUIUIF/BUVSBM$POWFDUJPOVOJUWFSTJPOUXPPGUIFXBSNBJSWFOUTNVTUCFQPTJUJPOFEJOUIFSPPNXIFSFUIF
BQQMJBODFJTJOTUBMMFEBOEUXPJOUIFPQQPTJUFSPPN
On the external sides of the long hopper you can control the
fl
ow of warm air, whereas the central part is always open to di
ff
use
the warm air by natural convection from inside the
fi
replace surround, to stabilize the temperature (see
fi
gure1).
4
3
(
D
D
A
A
A
A
A
1
D
2
A
1
F
F
F
E
D
1
a
d
b
e
c
f