Cameron NuFlo MC-II, User Manual

Page: 11 / 47

MC-II Flow Analyzer
7
To install the MC-II with the remote mount option, perform the following steps:
1. Place the “U” bolts around the pipe the MC-II is to be mounted on, then through the mounting bracket.
Note that the holes in the mounting bracket are arranged such that it may be used with horizontal or verti-
cal pipe. (Note: Disregard the center hole in the mounting bracket.)
2. Fasten the bracket with the lock washers and nuts.
3. Use the bolts, lock washers and nuts provided to attach the MC-II to the bracket. Position the MC-II to
the viewing angle desired before tightening the nut.
CAUTION: Before performing the next step, make sure the enclosure is in a well-ventilated area
and avoid breathing fumes that could be trapped inside. Under normal operating conditions,
the lithium battery that powers the MC-II is a sealed unit and poses no hazard when the enclo-
sure is opened. However, a leak in a lithium battery could expel toxic fumes into the enclosure.
If the battery appears to be damaged, adhere to the safety precautions and follow the disposal
instructions provided in Appendix C.
4. Open the enclosure and install the signal cable as follows:
a. Feed cable through the rubber grommet and make a knot or install a cable tie inside housing, allowing
enough free length to connect wires to the terminal connector.
b. Feed the black lead and shield into terminal connector number 2 and screw retainer down tight.
c. Feed red or white lead into terminal connector number 1 and screw retainer down tight.
d. Close the enclosure and retighten all eight screws.
Attaching Switchplate Labels
Each MC-II is shipped with a label set containing commonly used volume and flow rate units of measure
labels. Unless otherwise specified, the MC-II default units are barrels (volume), and barrels per day (rate). If a
different unit of measure will be used, place the appropriate label on the front panel below the respective LCD
viewing window. Make sure that the labels match the configuration (see “Recalibrating Your MC-II”).
!