15
2.2.3 Cleaning of the camera.
The camera shall NEVER be immersed in water or any other fluid. For cleaning, only use a light moist tissue.
2.2.4 Maintenance
No specific maintenance other than cleaning is applicable.
2.2.5 Repair and modification
Repair, modification and replacement of parts shall be done only by Adimec to maintain compliance with the
directive 89/336/EEC electromagnetic compatibility.
2.2.6 Mounting / Mechanical
2.2.6.1
2.2.6.1
2.2.6.1
2.2.6.1
C
C
C
Connectors
onnectors
onnectors
onnectors
Take care during handling of the camera. The Camera Link connector and the power connector should not be
damaged. The maximum tightening torque for the Camera Link connector may not exceed 0.26 Nm. Prevent the
entry of foreign objects or dirt to the connectors, as this will result in unreliable operation or damage.
2.2.6.2
2.2.6.2
2.2.6.2
2.2.6.2
Mounting screws
Mounting screws
Mounting screws
Mounting screws
Take notice of the maximum length of the screws that may be used for mounting of the camera. Using too long
screws can cause damage to the camera. Maximum screw length: 5 mm
Refer to chapter 10 for details.
Summary of Contents for ADIMEC-1000m
