CAMERA LINK ADIMEC-1000m, Operating And Technical Manual, Page: 34 / 67

32
100 LC or FD command failed. No power-up
defaults or factory defaults found.
This error indicates an internal NVRAM failure
To increase the reliability of the whole system it is good practice to verify each command by executing the ERR?
command.
4.2.8 Horizontal readout direction
The horizontal readout direction can be set to normal or mirrored readout. The selected direction applies in both
single and dual output modes.
Command syntax: MIx
x = 0 Normal readout
x = 1 Mirrored readout (left/right)
The current readout direction can also be read back from the camera.
Command syntax: MI?
4.2.9 Black Level
The black level is regulated automatically to the black level set point for both outputs eliminating temperature drift
and dark current offset errors when switching between long and shorter integration time.
The black level set point can be set for each individual CCD output.
Command syntax: BLx;y
x 12 bit black level setpoint for the left output
y 12 bit black level setpoint for the right output.
The black level set points are specified as 12 bit values with an allowed range of 0...4095. The black level in the
actual image depends on the selected camera output resolution and the selected digital gain as can be determined
from the camera block diagram.
The average black level in the image obtained from the camera becomes: