10
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
Settings
Wireless Setting
= W-DMX settings
(Wireless-DMX)
W-DMX On/Off
On = W-DMX enabled
Off = W-DMX disabled
Operating Mode
Receive = W-DMX module as receiver
Receive = W-DMX module as sender
Transmitting Mode G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link
Link = pair with W-DMX units. W-DMX must be enabled
on all devices, and the pairing with a transmitter be
retained (Receive Reset).
Unlink = decoupling of all devices
Receive Reset
No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
Display Reverse
= Flip display
On
= rotate display by 180° (e.g. for overhead installation)
Off
No display rotation
Display Backlight
= Display lighting
On
On permanently
Off
Deactivation after approximately 1 minute of inactivity
DMX Fail
= Operating status with DMX
signal fault
Hold
Last command is retained
Blackout
Activates blackout
Full On
All the LEDs are 100%
Stand Alone
Spotlight switches to the last selected stand-alone mode
Dimmer Curve
= Dimmer curve
Linear
Light intensity increases linearly with DMX value
Exponential
Light intensity can be finely adjusted at lower DMX
values and broadly adjusted at higher DMX values
Logarithmic
Light intensity can be broadly adjusted at lower DMX
values and finely adjusted at higher DMX values
S-Curve
Light intensity can be finely adjusted at lower and
higher DMX values and broadly adjusted at medium
DMX values
Dimmer Response
= Dimmer sensitivity
LED
Lamp responds abruptly to changes in DMX value
Halogen
Lamp behaves like a halogen spotlight with soft bright-
ness changes
Color Calibration
= Color calibration
(If one of the DMX factory
calibration modes is activated,
no other calibration can be
selected and the message
“no possible change in this
DMX Mode” will be shown
on the display. If one of the
DMX user calibration modes
is activated, RAW can be
selected as the alternative
calibration.)
RAW
individual color calibration. Brightness adjustment of 4
RGBW LED groups for all modes in the range 000-255
User calibration
Individual color calibration. Cross-mode brightness
setting of the 4 LED groups RGBW with values from
000 - 255
Factory calibration Factory-default calibration of R, G, B, and W (across all
operating modes). Select this setting to ensure the con-
sistent-looking presentation of color macros in stand-
alone mode and to control color macros with DMX.
Autolock
= Automatic locking of the
controls
On
Automatic locking of the controls after approximately 1
minute of inactivity. Display shown upon attempted use:
“Locked!"
To unlock: Press and hold UP and DOWN simultaneously
for approx. 5 seconds
Off
Automatic locking of the controls is disabled
LED Frequency
= LED PWM frequency
800Hz / 1200Hz /
2000Hz / 3600Hz /
12kHz / 25kHz
Configuration of LED PWM frequency
