8
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
• The fluid canister has a canister illumination to make fill level monitoring easier. In the heating phase, red LEDs are permanently on. Once
the heating phase is over and sufficient haze fluid is available, blue LEDs light up. If insufficient haze fluid is available for operation, the
red LEDs and 2 segments in the displays will begin blinking as a warning signal and the fluid pump will deactivate to protect the system.
Immediately disconnect the hazer from the power supply and top up the haze fluid level. The warning signal for insufficient haze fluid will
also activate even when Dark Mode is activated.
• Do not operate the hazer without haze fluid.
In order to remove fluid residue in the vaporizer system of your fog machine and thus ensure a long service life, clean the vaporizer system
regularly (approx. every 60 operating hours). To do so, use the special Cameo cleaning fluid for fog machines and follow the instructions on
the bottle label.
CONFIGURING DMX MODE
Press MODE to access the editing menu and press UP or DOWN until the display shows the menu item “Addr”. Confirm with ENTER and
then select the desired DMX start address by using the UP or DOWN buttons (hold down for fast value change) and confirm the selection
with ENTER.
ACTIVATE/DEACTIVATE DARK MODE
In some situations, the canister illumination and illuminated display can be disruptive. That’s why you have the option of activating dark
mode, which deactivates canister illumination and the display. Press MODE to access the editing menu and press UP or DOWN until the
display shows the menu item “dArK” (Dark Mode). Confirm with ENTER and use UP or DOWN to select “on” (activate dark mode) or “off”
(deactivate dark mode). Confirm your selection with ENTER. When dark mode is activated, the canister illumination will turn off immediately,
the display after approx. 15 seconds. Press one of the control keys to reactivate the display. The warning signal for insufficient haze fluid
will also activate even when Dark Mode is activated.
STANDALONE OPERATION
Standalone operation is only possible when neither a DMX controller nor the cable remote are connected to the device. If “Addr” is displayed
on the menu display, press MODE once to display “rEAd” (ready) and to be able to access the menu for standalone operation. Confirm with
ENTER. “P” (pump) is now displayed and you are able to set the haze output to a value between 1 and 100 with the UP and DOWN buttons
(hold down to change values quickly). Now press MODE to switch to menu item “F” (Fan) and to set the fan speed to a value between 1 and
100 with the UP and DOWN buttons. End haze output and reduce fan speed to the minimum speed by pressing ENTER.
OPERATION BY CABLE REMOTE
Operation by cable remote is only possible if no active DMX controller is
connected to the device. After connection of the cable remote to the appro-
priate REMOTE jack, the display will show "con" (Controller). The green LED
lights up on the remote control to signal that the heating phase is complete
and that the hazer is ready for operation.
MANUAL – Press and hold the button for the duration you wish to output
haze. The fluid pump will operate at maximum performance and the fan's
rotation speed can be set with the WIND SET controller.
CONT – switch for continuous haze output. The volume of haze is preset
with the OUTPUT controller and the fan speed with WIND SET. The red
display LED is lit up when this operating mode is activated.
TIMER – switch for timed haze output. The duration of the haze output and
paused haze output increases in equal amounts the further the INTERVAL
controller is turned in a clockwise direction. The volume of haze is preset
with the OUTPUT controller and the fan speed with WIND SET. The yellow
display LED is lit up when this operating mode is activated.
This CONT continuous haze output feature has priority over the TIMER timed
feature. The MANUAL control feature has priority over both other features.
