7
Al
l t
he
d
at
a
an
d
in
fo
rm
at
io
n
co
nt
ai
ne
d
he
re
in
is
c
on
si
de
re
d
su
bj
ec
t t
o
ch
an
ge
a
t a
ny
ti
m
e
an
d
at
o
ur
d
is
cr
et
io
n.
ENGLISH
SAFETY
The safety features can be connected and designated for:
- Re-opening
Re-opening during closure (2-C1);
- Re-closing
Re-closing during opening (2-CX, see dip 8-9);
- Partial stop
Partial stop gate stops if in motion with the resulting preparation for automatic closing (2-CX, see dip 8-9);
- Total stop
Total stop (1-2), gate stop, excluding any automatic closing cycle; to resume movement, you must use the pushbutton panel or
transmitter;
NOTE:
If an N.C. safety contact (2-C1, 2-CX, 1-2) is opened, the LED will fl ash to indicate this fact.
- Obstacle detection.
With the motor not running (gate closed, open, or after a total stop command), this feature hinders any movement if the safety
devices (e.g. photoelectric cells) detect an obstacle;
- Safety test function
Safety test function.
At every gate opening and closure command, the control unit checks the effi ciency of the safety features.
Possible accessories
- Cycle or courtesy lamp
Cycle or courtesy lamp (60W);
OTHER SELECTABLE FUNCTIONS
- Automatic closure. The automatic closure timer self-powers at the opening end stop. The modifi able set time is also subject to
modifi cations due to the intervention of possible safety accessories. This does not happen following a complete “stop” command
or if power is cut;
- Partial opening
Partial opening. Opening of the gate to allow for pedestrian traffi c; activated by connecting to clamps 2-3P and adjusted with
the PART. OP. trimmer. With this function, the automatic closing can vary in the following way:
1) Dip 12 set to ON: after a partial opening, the time for automatic closing functions independently of the adjustment of the TCA
trimmer and of the position of Dip 1; it is set at 8 seconds.
2) Dip 12 set to OFF: after a partial opening, the time for automatic closing is adjustable only if Dip 1 is set to ON;
- Cycle lamp
Cycle lamp. A light that illuminates the manoeuvring zone: it remains lit from the moment the doors begin to open until they
are completely closed (including the time required for the automatic closure).
If automatic closing is not activated, the lamp remains on only during movement (E-EX);
- Courtesy Light
Courtesy Light. A light that illuminates the manoeuvring zone: after an opening command, the light remains on for a fi xed time
of 5 minutes and 30 seconds (E-EX);
- “Maintained Action” function. Gate operation while keeping the pushbutton pressed (excludes the radio-control operation);
- Pre-fl ashing;
Pre-fl ashing; 5 seconds pre-fl ash during both opening and closing of the wing;
- Master function; the panel assumes all the command functions when two paired motors are used (see page 30);
- Slave function; this panel is exclusively controlled by the “MASTER”;
- Enabling functions
Enabling functions of partial stop or closure whilst opening, normally-closed contact (2-CX), select one of the two functions by
setting Dip
(see Function selections);
-Type of command
Type of command:
-open-close-reverse by button and transmitter;
-open-stop-close-stop by button and transmitter;
-open only by transmitter.
ADJUSTMENTS
- automatic closing time;
- Partial opening time.
5.7 Dip-Switches and functions
