P
age
35
- Manual
FA01554-EN
- 01/2021 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Parameter reset
Restore factory confi guration, except for the type of motor, calibration, users and password.
A4
Parameter reset
OFF (Cancel operation)
ON (Run operation)
Manoeuvre counter
View the number of total or partial operator manoeuvres (after maintenance).
The number of manoeuvres is the number shown multiplied by 100.
A5
Manoeuvre counter
Tot = Number of total manoeuvres (Default)
Par = Number of partial manoeuvres
Press the ENTER button to reset the number of
partial manoeuvres; the message “Clr” will appear.
FW version
Display the fi rmware version number.
H1
FW version
This shows the version of the board fi rmware. Use the < >
arrows to show the versions of the display board and the
control board.
Enable password
Set a 4-digit password. The password will be requested to anyone who wants to access the main menu.
H3
Enable password
OFF (Default)
ON
Use the arrows and the Enter button to dial the desired
code.
Forgotten password
If you forget your password, follow the procedure below.
Disconnect the control board from the power supply and wait for it to switch off .
Press and hold the < and > buttons, then reconnect the control board to the power supply.
Continue to press and hold the < > buttons until [ON/OFF] is displayed.
Select [ON].
Press ENTER to confi rm.
When you reset the control board, all saved users, set times and calibration operations are deleted.
