4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
4,7 KOHM
4,7 KOHM
+ - TC
+ - TC
TAMPER ALARM
TAMPER ALARM
ENGLISH
Page
11
- Manual code:
FA00464-EN
ver
.
1
03/2017 © C
AME S.p.a. - The data and information shown in this manual ar
e t
o be consider
ed as subject t
o change at any time and without the need for any advance warning.
If you want to control a relay with an Open Collector output (or relay
output), you will need to add a diode (1N4007) parallel to the relay
coil
GENERAL ALARM RELAY OUTPUTS
RELAY output 1 is a general alarm output and is not
programmable It follows the general alarm status and remains
active for the programmed time
Non-self-powered siren
Self-powered siren
PSTN TELEPHONE LINE
The PSTN telephone line is connected to the terminals [L, L] and
output to terminals [T, T] for switchboards or phones
"Simulated" phone lines (lines out from ADSL routers) can
cause interference on CONTACT-ID digital communications with
security services
Inputs Cabling
Balances are achieved with 4 7 kohm resistors at 5%
Yellow 4
Purple 7
Red 100
Gold 5%
NORMALLY OPEN (NA)
NORMALLY CLOSED (NC)
SINGLE BALANCE (SB)
PULSE OR INERTIA COUNTER (CI)
Output U1 is positive with output on (ON=13 8V DC) Output U1 is
factory set as TC (output on when system off and on during exit time
and when at least one area is on)
DOUBLE BALANCE (DB)
DOUBLE BALANCE SENSOR (DB)
DOUBLE BALANCE SENSOR (DB) WITH MICROWAVE
BLOCK WHEN CONTROL UNIT OFF (TC)
