P
age
25
- Manual
FA01610-EN
- 08/2021 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
FCA FCC warnings
Configure the method with which the FCA and FCC outputs report the boom status.
Configuration>
Functions
FCA FCC warnings
Off
Impulse
When the boom reaches the travel end point (while opening or closing), the FCA-CM1
or FCC-CM2 contact closes for one second.
Fixed
When the boom reaches the travel end point (while opening or closing), the FCA-CM1
or FCC-CM2 contact closes and remains closed.
Custom
The FCA-CM1 contact is closed with the boom in the open travel end position and
during the opening manoeuvre. The FCC-CM2 contact is closed with the boom in the
closed travel end position and during the closing manoeuvre.
Temperature control
Control the temperature by activating a cartridge heater or a fan.
Configuration>
Functions
Temperature control.
Off
Heater (Default)
Fan
Automatic closure
Set the time before automatic closure is activated, once the opening travel end point has been reached.
The function does not work if any of the safety devices are triggered when an obstacle is detected, after a complete stop, during a power outage or if
there is an error.
Configuration>
Times
Automatic close
Deactivated (Default)
From 1 to 180 seconds
Open warning light
Barrier status warning. Device connected to the 10-5 output.
Configuration>
Manage lights
Open warning light
Warning light on (Default) - The light stays on when the boom is moving or open.
Warning light flashing - The warning light flashes every half a second when the boom
is opening and remains on when the boom is open. The light flashes every second
when the boom is closing, and remains off when the boom is closed.
Light E1
Choose the type of device connected to the output.
Configuration>
Manage lights
Light E1
Flashing beacon (Default)
Cycle lamp
The light remains off if an automatic closing time is not set.
Pre-flashing time
Set the time for which the beacon is activated before each manoeuvre.
Configuration>
Manage lights
Pre-flashing time
Deactivated (Default)
1 to 10 seconds
