1
7
6
5
8
2
4
4
9
3
Pa
g.
44
-
Ma
n
u
al
c
od
e:
11
9
A
U
1
4
E
N
11
9
A
U
1
4
E
N
ve
r.
1
1
0
9
/2
0
14 © C
A
M
E c
an
ce
lli
auto
m
ati
ci
S
.p.
A
. -
Th
e d
ata a
n
d i
nf
or
m
ati
on r
ep
orte
d i
n th
is
in
sta
lla
tio
n m
an
u
al
a
re s
u
sc
ep
tib
le to c
h
an
g
e at a
ny ti
m
e a
n
d w
ith
ou
t o
b
lig
ati
on
o
n C
A
M
E c
an
ce
lli
auto
m
ati
ci
S
.p.
A
. to n
otify u
se
rs.
ENGLISH
4.3 Description of parts
1. Gate pin-housing ring
2. Gearmotor pin-housing ring
3. Gearmotor mobile ring
4. Endstop adjustment set screw
5. Release
group
6. Cover
7. Operator
8. In-ground
case
9. Custom key for release
group
4.4 Dimensions
(mm)
5 Installation
Before installing, do the following:
• Make sure you have a suitable omnipolar cut-off device with contacts more than 3 mm apart, and independent (sectioned off)
power supply.
• Make sure you have suitable tubing and conduits for the electrical cables to pass through and be protected against mechanical
damage.
• Fit tubing to drain away any water leaks which may cause oxidation.
• Make sure that any connections inside the case (that provide continuance to the protective circuit) be fitted with extra
insulation as compared to the other conductive parts inside;
• Make sure the structure of the gate is sturdy, the hinges work and that the is no friction between moving and non-moving parts.
• Make sure there is a mechanical stop for opening and closing.
Installation must be carried out by expert qualified personnel and in full compliance with current regulations.
5.1 Preliminary checks