CAME EMEGA, Installation Manual

Page: 49 / 128

10 11 E RX TX 1 2 3 5 7 2 CX CY
A B GND
10 2 TX C NC
+ -
TX 2
TX RX
10 11 E RX TX 1 2 3 5 7 2 CX CY
A B GND
+ - NO C NC + -
TX RX
DELTA S / DIR
DELTA
10 11 E RX TX 1 2 3 5 7 2 CX CY
10 11 E RX TX 1 2 3 5 7 2 CX CY
A B GND
DF
DF DFI
Page
1
7
17 - Manual
FA
01
19
5-
EN
- 0
6
/2
01
8 - © CAME S
.p.
A
.. - The contents of this manual may change, at any time, and without notice. - Translated original in
structions
Photocells
Configure the CX or CY (NC) contact, input for
safety devices such as photocells, compliant with
the EN 12978 standard.
See CX (F2 function) or CY (F3 function) input
functions in:
- C1 reopening during closing. While the door
is closing, the opening of the contact causes
the reversal of the direction of movement until
completely open.
- C4 waiting for obstacle. The door stops if it
is moving, and movement is resumed once the
obstacle has been removed.
N.B. if the CX and CY contacts are not used
contacts CX and CY, they must are disabled in
programming.
Sensitive edges
Configure the CX or CY (NC) contact, input for
safety devices such as sensitive edges, compliant
with the EN 12978 standard. See CX (F2 function)
or CY (F3 function) input functions in:
- C7 reopening during closing. While the door
is closing, the opening of the contact causes
the reversal of the direction of movement until
completely open.
N.B. if the CX and CY contacts are not used
contacts CX and CY, they must are disabled in
programming.
Safety devices
DF with DFI connection
control panel.