CAME 002ZL60 Installation Manual Download Page 18

Page: 18 / 64

- M

- 0

- © C

E S

.p.

. - T

e c

onte

nts of th

ay b

e c

ed, at a

ny ti

e, a

d w

ith

t n

oti

• This control panel is expressly designed to be assembled to partly-completed machinery
or equipment so as to build machinery as regulated by European Directive 2006/42/CE. The
ﬁ nal installation must conform to Directive 2006/42/CE and to any harmonized reference
standards.  Given  these  considerations,  all  operations  provided  in  this  manual  must  be
performed by skilled, qualiﬁ ed staff . • This product should only be used for the purpose for
which it was explicitly designed. Any other use is dangerous. CAME S.p.A. is not liable for any
damage caused by improper, wrongful and unreasonable use. • Before installing the control
panel, make sure that the guided part is in proper mechanical order, that it opens and closes
properly and that it is balanced - otherwise, do not continue until you have ﬁ rst complied
with all safety provisions. • Make sure that people cannot be entrapped between the guided
and ﬁ xed parts, when the guided part is set in motion. • The control panel cannot automate
any guided part that includes a pedestrian gate, unless the latter can be enabled only when
the pedestrian gate is secured. • Make sure the fastening points and the anchoring surface
are solid and protected from impacts. Only use suitable nuts, bolts, dowels, and so on. •
Laying the cables, installation and testing must follow state-of-the-art procedures as dictated
by applicable standards and laws. • Check that the temperature ranges given and those of
the location match. • Demarcate the entire site to prevent unauthorized personnel to enter;
especially children and minors. • Use proper means of protection to prevent any mechanical
hazards from people caught in the movement of the automated operator. Any residual risks
must be highlighted by affi  xing pictograms, in clear view. These must then be explained to the
end user of the machinery. • Fit, in plain sight, the machine's ID plate when the installation is
complete. • All command and control devices must be ﬁ tted so that they are clearly visible,
at a proper safety distance from the maneuvering guided-part and where they cannot be
reached through said guided part. • Unless we are talking about key-pad selectors, key-switch
selectors, transponder selectors, and so on, the maintained-action control devices must be
ﬁ tted at least 1.5 m above ground, where they cannot be reached by the general public. • The
manufacturer declines any liability if non-original parts are used. In which case the warranty
will cease to be eff ective. • All maintained-action switches that are connected to the control
panel must be positioned so that the maneuvering area is completely visible from the switches,
yet far enough away from any moving parts. • Make sure that the operator has been properly
adjusted and that any associated safety and protection devices, as well as the gearmotor's
manual release, are working properly. • If the power-supply cable is damaged, it must be
replaced by the manufacturer or by a licensed technical-assistance center or by duly trained,
skilled staff , to prevent any risks. • During all phases of the installation make sure you have
cut off  the mains power source. • The electrical cables must run through corresponding tubes
or conduits to ensure suitable protection against mechanical damage and they must not come
into contact with parts that could heat up during use. • Make sure you have set up a suitable
dual pole cut off  device along the power supply that is compliant with the installation rules.
It should completely cut off the power supply according to category III surcharge conditions.