CAME 002ZL60, Installation Manual

Page: 29 / 64

A
M2 M1
A
B
B
M2
M1
A
M2
M1
A
B
B
A
M2 M1
A
B B
p.
13
- M
an
u
al
FA
01
04
0-
EN
- 0
2
/2
0
1
8
- © C
A
M
E S
.p.
A
. - T
h
e c
onte
nts of th
is
m
an
u
al
m
ay b
e c
h
an
g
ed, at a
ny ti
m
e, a
n
d w
ith
ou
t n
oti
ce
.
Timed slow-downs with Encoder disabled

Set the OP TIME trimmer to maximum, set the SENS
trimmer to half, save the trimmers' values, disable the
Encoder, enable the timed slow-down function.
- Perform a self-learning run of the leaf travel.
The operator will perform a series of maneuvers to establish
the starting slow-down and limit-switch points.
= 25% of the operating time at slowed down speed
when opening.
= 25% of the operating time at slowed down speed when
closing.
Resetting the opening and closing slow-down starting points
- Close the gate leaves.
- Perform a self-learning run of the leaf swing arc. When M2
reaches the closing slow-down starting point, during an
opening maneuver
B (10/45 %), press the PROG button.
- Again press the PROG button when M2 reaches the
opening slow-down starting point, during the same
maneuver
A
(55/90 %).
Repeat the procedure for M1.
Auto-learning of the gate-leaf travel
With the Encoder enabled (the default setting)
- Select the Dip-switch and press the PROG button the control board as explained in the functions
programming section.
The operator will perform a series of maneuvers to establish
the starting slow-down and limit-switch points.
= 25% of the movement area at slowed down speed
when opening.
= 25% of the movement area at slowed down speed
when closing.
With Encoders and timed slow-downs disabled

If the Encoder and Slow-down functions are both
disabled, the gate leaves will open or close completely at a
constant, limited speed of 50% of the top speed.