6
EQUIPMENT NEEDED FOR INSTALLATION
Prior to installing your lift truck scale, gather all equipment (listed below)
needed to complete the installation;
-
1/2-inch hex allen wrench for removing and reinstalling the bottom cleats
-
1-1/2 inch open end wrench for adjusting the carriage adjustment bolts and
tightening the nuts of the carriage adjustment bolts
-
Cutting pliers for cutting the wire ties
-
Adjustable wrench (10-inch) for installing the cable protection guard
-
5/16-inch hex allen wrench for removing and installing fork stops
-
4-inch grinder
INSTALLATION: SCALE SECTION
NOTE: The Scale Section is shipped with the carriage adjustment bolts backed
out. You must adjust the carriage adjustment bolts. Improper installation
of the scale section causes most weighing problems. When installing the
the scale section keep the following in mind.
1)
Scale section must touch the carriage at four points.
2)
Scale section must be as parallel as possible to the carriage.
3)
Scale section must not rock, swing, or slide in any direction.
INSTALLATION:
1)
Remove forks from your existing truck. Remove backrest if required
2)
Make sure the carriage face is not too rough; if it is, use the grinder
over any uneven areas.
3)
Remove the bottom cleats from the scale section using the 1/2 inch
hex allen wrench.
4)
Remove the cable protection guard and bolt. Install the lifting eye provided.
This allows you to lift the complete scale for installation.
Summary of Contents for DL-CSW-10AT-LFT
Page 1: ......
