Chapter 3: Installation Components
Antenna Connection
phn-4026 003v000
Page 3-4
Antenna Connection
RFU-C can be mounted directly for all frequencies (6-38 GHz) using the following antenna types (for integrated
antennas, specific antennas PNs are required):
•
Andrew: VHLP series
•
Radiowaves: HP series
•
Cambium: CNT series
For remote mount installations, the following flexible waveguide flanges should be used (millimetric). The same
antenna type (integrated) as indicated above can be used (recommended).
Other antenna types using the flanges listed in the table below may be used:
Table 9
Other antenna types
Frequency
Circ. WG
Diameter
Rect. WG
Flange Des.
Radio Side
(Remote)
Flange Des.
Flex WG Side
A Flange Des.
Flex WG Side
B Flange Des.
Antenna
(Remote)
Flange Des.
Band
Range
(GHz)
6(L/U)
GHz
5.8-7.1
31.8 mm
WR137
UDR70
PDR70
PDR70
UDR70
7/8 GHz
7.1-8.5
26 mm
WR112
UBR84
PBR84
PBR84
UBR84
10/11 GHz 10.0-11.7 18 mm
WR90
UBR100
PBR100
PBR100
UBR100
13 GHz
12.7-13.3 15 mm
WR75
UBR120
PBR120
PBR120
UBR120
15 GHz
14.5-15.4 13.5 mm
WR62
UBR140
PBR140
PBR140
UBR140
18 GHz
17.7-19.7 10.5 mm
WR42
UBR220
PBR220
PBR220
UBR220
23 GHz
21.2-23.6 9 mm
26 GHz
24.5-26.6 8 mm
28-31 GHz 27.3-29.5 7 mm
WR28
UBR320
PBR320
PBR320
UBR320
32 GHz
31.8-33.4 6.5 mm
38 GHz
37.0-40.0 5.5 mm
If a different antenna type (CPR flange) is used, a flange adaptor is required. Please contact your Cambium
Networks representative for details.
Note
Conductive grease must be applied to the screws that connect the RFU-C to the antenna interface.
