Chapter 3: Configuration Guide
Configuring a Link Using the Quick Configuration Wizard
phn-3965_006v002
Page 3-5
Configuring a Link Using the Quick Configuration
Wizard
The Web EMS provides wizards to configure radio links. The wizards guide you through configuration of the basic
radio parameters and services necessary to establish a working pipe link. The following link types can be
configured with the Quick Configuration wizard:
•
1+0
–
Configures a 1+0 radio link consisting of a user-selected Ethernet (or LAG) and radio interface
connected. This link passes traffic between the radio and Ethernet interfaces via a point-to-point pipe service.
See
Configuring a 1+0 Link Using the Quick Configuration Wizard
•
1+0 Repeater
–
Configures a 1+0 radio link that passes traffic between two user-selected radios via a point-to-
point pipe service. This type of link is used to configure a node that functions as a repeater, passing traffic
between two other nodes. See
Configuring a 1+0 (Repeater) Link Using the Quick Configuration Wizard
•
1+1 HSB
–
PTP 820G only. Configures a 1+1 HSB radio link consisting of a user-selected Ethernet interface or
LAG and two radio interfaces in a 1+1 HSB configuration, one active and one standby. This link passes traffic
between the active radio interface and the Ethernet interface via a point-to-point pipe service. See
Configuring a 1+1 HSB Link Using the Quick Configuration Wizard
. For a detailed explanation of 1+1 HSB and its
Configuring HSB Radio Protection
•
1+1 HSB-SD
–
PTP 820G only. Configures a 1+1 HSB radio link with Space Diversity, consisting of a user-
selected Ethernet interface or LAG and two radio interfaces in a 1+1 HSB configuration, one primary/active
and one diversity/standby. This link passes traffic between the radio interfaces and the Ethernet interface via
a point-to-point pipe service. See
Configuring a 1+1 HSB-SD Link Using the Quick Configuration Wizard.
For a
detailed explanation of 1+1 HSB-SD and its requirements, see
Configuring HSB Radio Protection
•
N+0 Multi-Carrier ABC
–
Configures a 2 + 0 Multi-Carrier ABC group consisting of an Ethernet interface or LAG
and the two radio interfaces. See
Configuring an N+0 Multi-Carrier ABC Link Using the Quick Configuration
For a detailed explanation of Multi-Carrier ABC and its requirements, see
You can also use this wizard to configure XPIC between the radios within the Multi-Carrier ABC group. For a
detailed explanation of XPIC and its requirements, see
Because the Quick Configuration wizard creates Pipe links, you cannot add an interface to a link using the Quick
Configuration wizard if any service points are attached to the interface prior to configuring the link. See
Configuring a 1+0 Link Using the Quick Configuration Wizard
To configure a 1+0 link using the Quick Configuration wizard:
1
Select
Quick Configuration > PIPE > Single Carrier > 1+0
. Page 1 of the 1+0 Quick Configuration wizard opens.
Summary of Contents for PTP 820 Series
