Chapter 5: Installation
Installing the ODU
Page 5-7
Low profile bracket on large pole
1 Fix the low profile bracket to the back of the ODU using the M6 bolts and washers provided.
Tighten the four bolts to a torque setting of 5.0 Nm (3.7 lb ft). This step is common with the low
profile bracket on a smaller diameter pole.
2 Close the bracket. Two M6 bolts should pass through slots in the fixed portion of the bracket.
Ensure that the spring and plain washers of the M6 bolts are on the outside of the bracket
assembly. Tighten the four M6 bolts to ensure that the bracket cannot open accidentally. Feed
the Jubilee straps through the slots in the adaptor plate. This is similar to the procedure for the
large diameter extension kit.
3 Hoist the ODU to the mounting position.
4 Attach the bracket to the pole using the Jubilee straps.
5 Adjust the azimuth to achieve visual alignment. Tighten the Jubilee straps to a torque setting of
6.0 Nm (4.5 lb ft).
6 Adjust the elevation to achieve visual alignment. Tighten the four M6 bolts to a torque setting of
5.0 Nm (3.7 lb ft).
1
4
