PMP 450 Configuration and User Guide
Task 5: Configuring security
pmp-0050 (May 2012)
2-75
Attribute
Meaning
Ethernet Access Control
If you want to prevent any device that is connected to the Ethernet port
of the SM from accessing the management interface of the SM, select
Ethernet Access Disabled
. This selection disables access through this port
to via http (the GUI), SNMP, telnet, ftp, and tftp. With this selection,
management access is available through only the RF interface via either
an IP address (if
Network Accessibility
is set to
Public
on the SM) or the
Session Status or Remote Subscribers tab of the AP.
This setting does not prevent a device connected to the Ethernet port
from accessing the management interface of
other SMs
in the
network. To prevent this, use the
IP Access Filtering Enabled
selection in the
IP Access Control
parameter of the SMs in the
network. See
IP Access Control
below.
If you want to allow management access through the Ethernet port, select
Ethernet Access Enabled
. This is the factory default setting for this
parameter.
IP Access Control
You can permit access to the SM from any IP address (
IP Access Filtering
Disabled
) or limit it to access from only one, two, or three IP addresses
that you specify (
IP Access Filtering Enabled
). If you select
IP Access
Filtering Enabled
, then you must populate at least one of the three
Allowed Source IP
parameters or have no access permitted from any IP
address, including access and management by Prizm.
Allowed Source IP
1 to 3
If you selected
IP Access Filtering Enabled
for the
IP Access Control
parameter, then you must populate at least one of the three
Allowed
Source IP
parameters or have no access permitted to the SM from any IP
address. You may populate as many as all three.
If you selected
IP Access Filtering Disabled
for the
IP Access Control
parameter, then no entries in this parameter are read, and access from all
IP addresses is permitted.
Summary of Contents for PMP 450
