Cambium Networks ePMP 1000, User Manual

Page: 218 / 478

CAMBIUM NETWORKS
026v003
218
Attribute Meaning
Protocol UDP: Packet forwarding decisions are based on UDP packets.
TCP: Packet forwarding decisions are based on TCP packets.
Port Begin Configure the beginning of the range of wireless ports to match for
forwarding to LAN IP.
Port End Configure the end of the range of wireless ports to match for
forwarding to LAN IP.
Forwarding IP Configure the LAN IP of the device situated below the SM which
receives the packets forwarded based on the Separate Management
IP Port Forwarding Table configuration.
Mapped Port Configure the port of the device situated below the SM which
receives the packets forwarded based on the Separate Management
IP Port Forwarding Table configuration.
Point-to-Point Protocol over Ethernet (PPPoE)
PPPoE Point-to-Point Protocol over Ethernet: Used for Encapsulating PPP
frames inside Ethernet frames.
Service Name An optional entry to set a specific service name to connect to for the
PPPoE session. If this is left blank the SM accepts the first service
option that comes back from the Access Concentrator specified
below, if any. This is limited to 32 characters.
Access Concentrator An optional entry to set a specific Access Concentrator to connect to
for the PPPoE session. If this is blank, the SM accepts the first Access
Concentrator which matches the service name (if specified). This is
limited to 32 characters.
Authentication ALL: This means that CHAP authentication will be attempted first,
then PAP authentication. The same password is used for both types.
CHAP: This means that CHAP authentication will be attempted.
PAP: This means that PAP authentication will be attempted.
Username This is the CHAP/PAP username that is used. This is limited to 32
characters.
Password This is the CHAP/PAP password that is used. This is limited to 32
characters.
MTU Size Maximum Transmission Unit; the size in bytes of the largest data
unit that the device is configured to process inside the PPPoE tunnel.
This field allows the operator to specify the largest MTU value to use
in the PPPoE session, if PPPoE MSS Clamping is Enabled. The user
will be able to enter an MTU value up to 1492. However, if the MTU
determined in LCP negotiations is less than this user-specified value,
the SM uses the smaller value as its MTU for the PPPoE link.