Cambium Networks ePMP 1000, User Manual

Page: 116 / 478

CAMBIUM NETWORKS
026v003
116
Configuring connectorized radios using the Quick Start menu
The Quick Start tab contains a listing of parameters required to configure a simple radio link and to
configure requisite networking parameters. After configuring an AP, SM and resetting both
devices, the SM is ready to associate (register) to the AP.
Figure 32 AP Quick Start menu
To configure an AP via the Quick Start menu, follow this procedure:
Procedure:
1 Start the web browser from the management PC.
2 Navigate to the Quick Start menu
3 Configure the parameter Radio Mode :
This parameter controls the function of the device – All ePMP devices may be configured to
operate as an Access Point (AP), Subscriber Module (SM) or as a Spectrum Analyzer. For
initial link bring-up, choose Access Point.
4 Configure the parameter Access Point Mode:
This parameter controls the mode of operation of the Access Point – An AP may be
configured to operate in TDD mode for multipoint access, PTP mode for point-to-point access
using TDD, Standard WiFi or as an ePTP Master. For initial link bring-up, choose TDD. When
the AP is an ePTP Master, the system does not support GPS Synchronization but is able to
provide significantly lower latency than other modes. QoS (MIR and traffic priority) capability
and Link Quality/Capacity indicators are not available in this mode. Configuring the AP in
Standard WiFi mode allows any 802.11 client to register to the AP.