ADC 2
Further requirements:
•
Do not place the instrument in a location where the tempera-
ture significantly changes (e.g. under an air conditioning duct
or by a window). Significant changes in temperature will af-
fect the performance of the unit.
•
Do not place the instrument in direct sunlight. Direct sunlight
will disturb the measurement of the CCD sensor.
•
Do not use the instrument in an environment with moving
ambient air (draft).
•
Do not expose the instrument to any strong vibration or
shock.
•
Avoid placing the instrument near equipment that radiates
heat. Do not place the instrument near gas burners, electric
heaters or ovens.
•
Do not place the instrument near equipment that generates
intense magnetic fields such as electric welding equipment,
high frequency furnaces, pole transformers, etc.
•
Protect the instrument from excessive dust.
•
Connect the instrument to power lines that are free from
sudden changes or voltage fluctuations.
•
If you must use power motor driven equipment (such as a
stirrer or shaker) in the same line as your instrument, ensure
that a noise reduction unit is in the same power line
2.3. Conditions for the installation
Confirm that the following requirements exist before installing
the instrument:
Power supply and ground
Line voltage:
100 – 240V (see rating plate on instrument).
Frequency:
50 / 60 Hz
Power capacity:
20 W
Ground terminal:
A grounded outlet should be located within 2
meters of the instrument.
Connection for Exhaust tube
Manual, August 2005
Page 7
